Simple, Quick Installation
The DAMAR™ TruckDeck™ can be installed in and removed from your truck bed as quickly as 15 minutes!
Step 1
Attach corner leg supports (Figure 1) to the outer structural frame members with
the supplied bolts and wing nuts (Figure 2).
Figure 1
Figure 2
Step 2
Place one of the center leg supports in the truck bed within easy reach (Figure 3). Lift
one side of the TruckDeck™ into the truck bed (Figure 4).
Figure 3
Figure 4
Step 3
Position the first half of the TruckDeck™ into its correct horizontal orientation
(Figure 5), and use the center leg support to hold the TruckDeck™ in position (Figure
6).
Figure 5
Figure 6
Step 4
Lift the remaining TruckDeck™ half into the truck bed (Figure 7) and move it into position
lowering the center seam onto the center leg support (Figure 8).
Figure 7
Figure 8
Step 5
Secure the two halves of the TruckDeck™ together by fastening the two inner frame
members together through the predrilled holes with the supplied bolts and wing nuts
(Figure 9). Place the front and rear structural support members at each end of the
TruckDeck™ (Figure 10).
Figure 9
Figure 10
Step 6
Fasten the forward structural support to the underside of the TruckDeck™ (Figure
11), then secure the rear frame member with the supplied bolts and wing nuts (Figure
12).
Figure 11
Figure 12
Step 7
Install the rear hatch by aligning the predrilled holes with the preinstalled hinges
on the TruckDeck™ and secure with included bolts and wing nuts (Figure 13). Attach
the rear hatch gas springs to the ball studs on the hatch door and on the rear support
(Figure 14).
Figure 13
Figure 14
Step 8
Secure the fully assembled TruckDeck™ to your truck by connecting the turnbuckles
to your factory installed tie-downs (Figure 15). The TruckDeck™ should have approximately
0.25'' of separation from the truck bed walls around the entire perimeter. Once your TruckDeck™
is securely fastened you are ready to drop in your Load-N-Go™ containers and hit the
road (Figure 16)!
Figure 15
Figure 16
Center Support
The center leg functions not only as an installation aide but can be left in place
for added strength when a larger load capacity is needed on top of the CargoDeck.
